UNetbootin - Installation and Screenshots

Installation & Screenshots

1. If using Windows, run the file, select a distribution, floppy/hard disk image, or kernel/initrd to load, select a target drive (USB Drive or Hard Disk), then reboot once done.

   

2. If using Linux, make the file executable (using either the command chmod +x ./unetbootin-linux, or going to Properties->Permissions and checking "Execute"), then start the application, you will be prompted for your password to grant the application administrative rights, then the main dialog will appear, where you select a distribution and install target (USB Drive or Hard Disk), then reboot when prompted.

   

   

3. After rebooting, if you created a Live USB drive by selecting "USB Drive" as your install target, press the appropriate button (usually F1, F2, F12, ESC, or backspace) while your computer is starting up to get to your BIOS boot menu and select USB drive as the startup target; otherwise if there's no boot selection option, go to the BIOS setup menu and change the startup order to boot USB by default. Otherwise, if you did a "frugal install" by selecting "Hard Disk" as your install target, select the UNetbootin entry from the Windows Boot Menu as the system boots up.

» See Live USB Creation Guide.

Removal Instructions (Applicable only to Hard Disk / "frugal installs")

If using Windows, UNetbootin should prompt you to remove it the next time you boot into Windows. Alternatively, you can remove it via Add/Remove Programs in the Control Panel.

If using Linux, re-run the UNetbootin executable (with root priveledges), and press OK when prompted to uninstall.

Removal is only required if you used the "Hard Drive" installation mode; to remove the bootloader from a USB drive, back up its contents and reformat it.

Uninstalling UNetbootin simply removes the UNetbootin entry from your boot menu; if you installed an operating system to a partition using UNetbootin, removing UNetbootin will not remove the OS.

To manually remove a Linux installation, you will have to restore the Windows bootloader using "fixmbr" from a recovery CD, and use Parted Magic to delete the Linux partition and expand the Windows partition.

Installing Other Distributions Using UNetbootin

Download and run UNetbootin, then supply it with the appropriate ISO (CD image) file, floppy/hard disk image, or kernel and initrd files when prompted (see screenshot). Check your distribution's download page to find the appropriate file; if in doubt use the ISO file.

If you're loading an ISO file or floppy/hard disk image, that's all that's required (just press "OK" to start installing); otherwise if you're manually specifying kernel and initrd files and you'd like to specify special booting options, check the distribution's boot configuration files (usually after the "kernel" line in either isolinux.cfg, syslinux.cfg, menu.lst, or grub.conf) and supply them on the "Option" line.

Posted via email from BitHacker's posterous